Yes, it is generally recommended to wet sand the clear coat before buffing the paint. 4. Get as much dust off as possible (even on areas not being painted). This will help the paint to adhere to the surface of your car better. Take a look at the two OP results pictures and you'll see instantly what I mean. Allow each layer to dry for the recommended amount of time before applying the next one. You can see that the reflective gloss is absent on the hood. The first coat of paint, you need to spray it lightly. After the final coat of clear paint has been applied, buff the paint with a dual-action polisher or by hand with a soft cloth and buffing compound to achieve a glossy finish. Wet sanding and buffing when you're done would make it smooth as glass, which would not match the orange peel on the oem paint. Start with 1000 grit sandpaper, you can use this with water to carry away the fine debris. Additionally, if you are using the paint to cover up flaws or make an unfinished surface look complete, then you likely need to apply several heavy coats of paint until you achieve your desired coverage. 2. If you can't find enough heat, try using a hairdryer and heating up the headlight until its pretty hot, then let it cool a bit and spray it. In basements, dust will shake down from the floor joists, especially if someone is stomping around upstairs, so staple painter's plastic to the ceiling. I would go light to thick as you said you did. Could a subterranean river or aquifer generate enough continuous momentum to power a waterwheel for the purpose of producing electricity? This should be done till the paint starts to flake off. 2023 Painting Doctors | All Right Reserved. Silver is also finicky. For complete removal of clear coat layers, 36-grit or 40-grit sandpaper may be necessary. Before you spray on the primer, make a hook out of a wire coat hanger to hang the part on. You can use fine-grit sandpaper for this, but make sure that you do not sand too hard or you could damage the surface of your car. Rattle on. Airbrush vs. Rattle Can for Clears - FineScale Modeler - Essential Pro Tips for Spray Can Painting - Model Airplane News Use this information at your own risk. check out. Once clear coat is applied you need to sand it with low grit wet and dry sand paper and then rub it out with low grit rubbing compound.
how to spray clear coat rattle can